Operation Manual

123
Setup Menu
Network Setup —Continued
While the system sending information is called a server,
the machine receiving the data is called a “client.”
Multiple clients can be connected to a single server.
From the viewpoint of Net-Tune Central, the RDC-7.1
is a client.
a. Client Name
Confirm the client name used on the Net-Tune system.
The client name is assigned by the RDC-7.1. You
cannot change the assigned name.
b. Wakeup on LAN
Specify the network condition on standby of the
RDC-7.1.
Enable: To be left connected.
Disable: To be disconnected while the RDC-7.1 is on
standby to save electricity.
c. NTSP Port
Specify the TCP/IP port to communicate with Net-Tune
Central. This setting is to determine the port for
intercommunication and needs to match the setting at
Net-Tune Central. Do not change the port number
unless absolutely necessary. Press the [ ]/[ ]/[ ]/
[ ] buttons to select numerics, and then press the
[Enter] button. When all numerics are entered, exit from
the character entry mode.
Note:
When the settings are complete, press the [Return]
button to return to the Network Setup menu. Use the
[ ]/[ ] buttons to select “ → Save Settings,” and then
press the [ ] button to save settings described in
“Network Setup” on pages 122 and 123. After setting,
saving data will take a few seconds. While saving data,
be sure not to turn off the power, otherwise the data will
be lost.
Specifications:
Ethernet port: 10BASE-T
File type: MP3, WMA, WAV
(supports non-compression format and sampling
frequency of 32, 44.1, 48 kHz)
(WMA files with contents protected cannot be played)
Lock/Version Setup
The following sub-menus allow you to lock your
settings or display the software version of the RDC-7.1.
a. Lock
You can lock all of the setting menus to prevent settings
from being changed by mistake.
Locked: Powering on and off will resume the setting
when it was locked, discarding any modification that
was made after locking.
Unlocked (Default): No lock on setting operations.
This section deals with confirmation of the firmware
version for each program currently installed in your
RDC-7.1 (No procedure is provided for updating the
firmware).
a. Master version
Confirm the firmware version for the main program.
b. i.LINK(IEEE1394) version
Confirm the firmware version for i.LINK. This item
appears when the i.LINK(AUDIO) terminal board [A] is
inserted.
c. Net-Tune version
Confirm the firmware version for the Net-Tune
program. This item appears when the ETHERNET
terminal board [B] (for Net Audio) is inserted.
d. HDMI version
Confirm the firmware version for HDMI. This item
appears when the HDMI terminal board [L] is inserted.
Client Sub-menu
Lock Setup Sub-menu
Firmware Version Sub-menu