User Manual

Connections
15
It
De
5. Use the direction ( / ) buttons to select “Wi-Fi
Setup”, and then press the ENTER button when “Start”
is displayed.
6. Press the ENTER button when “Scan Networks” is
displayed.
7. Use the direction ( / ) buttons to select the SSID of
the access point and press the ENTER button.
0 If you changed the initial setting of the access point
to skip password entry, step 8 is unnecessary.
0 If you changed the initial setting of the access point
to hide the SSID, see “When the access point is not
displayed”.
8. Press the direction ( / ) buttons to select an
authentication method from the following and press the
ENTER button.
Enter Password: Enter the password of the access
point to establish connection.
Enter the password on the display.
0 For information on how to input characters, see
“Inputting characters” (
> 33) under “Various
settings”.
Push Button: Use the automatic setting button of the
access point to establish connection.
Hold down the automatic setting button of the access
point for the necessary seconds, select “OK” on the
display and press the ENTER button.
PIN code: Select this method when the automatic
setting button of the access point is beyond the reach.
The 8-digit PIN code is displayed. Register the
displayed PIN code to the access point, select “OK” on
the display and press the ENTER button. For how to
register the PIN code to the access point, refer to its
instruction manual.
When connection is successful: The setup menu ends
automatically.
0 You can confirm the connection status by pressing the
SETUP button and selecting “5. Network”-“Status”.
SSID
When the access point is not displayed
Use the direction ( ) button to select the “Other...” on
the display and press the ENTER button. Input the
SSID. When “Security” is displayed on the display,
make the following settings according to the router
setting.
0 For information on how to input characters, see
“Inputting characters” (> 33) under “Various
settings”.
∫ WPA/WPA2 method
Use the direction ( / ) buttons to select the “WPA”
or “WPA2” on the display and press the ENTER
button. Input the password.
∫ WEP method
Use the direction ( / ) buttons to select the “WEP”
on the display and press the ENTER button. Input the
password. When “Default Key” is displayed on the
display, select the Default Key ID and press the
ENTER button.
0 If encryption setting has not been made on the
wireless LAN router, use the direction ( / )
buttons to select the “None” on the “Security”
display and press the ENTER button.
TX-8140_mst.book 15 ページ ２０１５年９月２９日 火曜日 午前１１時１３分