User Manual

Various settings
36
Firmware update
Update the firmware via network or USB connection.
Visit the our website to download the latest firmware. (If
no firmware is listed, no firmware update is available.)
∫ Updating the firmware via network
You can update the firmware by connecting the unit to a
network.
Update procedures
1. Press the SETUP button.
2. Use the direction ( / ) buttons to select “7. Firmware
Update” and press the ENTER button.
0 If it is not displayed, wait for a moment until the
network feature starts.
3. Use the direction ( / ) buttons to select “Update via
NET” and press the ENTER button.
0 The option does not appear when no firmware
update is available.
4. Press the ENTER button with “Update” selected to
start update.
“Completed!” appears on the display when updating is
completed.
5. Press the
Í ON/STANDBY button on the front panel
to put the unit into standby.
0 Do not use the Í button on the remote control for
this operation.
The update is complete. The unit’s firmware has been
updated to the latest version.
When an error message appears
When an error occurs, “*-** Error!” appears on the display
of this unit. (Characters and numbers appear in place of
the asterisks.) Refer to the descriptions below to check
the meaning.
Error code
*-01, *-10:
The Ethernet cable could not be
recognized. Connect the Ethernet cable properly.
*-02,*-03,*-04,*-05,*-06,*-11,*-13,*-14,*-16,*-17,*-18,
*-20,*-21:
Internet connection could not be
established. Check the following points.
- Whether the router is turned on
- Whether this unit and router are connected to the
network
Try to disconnect and then connect again the power to
the unit and router. This may solve the problem. If you
are still unable to connect to the Internet, the DNS
server or proxy server may be temporarily down.
Check the service status with your ISP provider.
Others: Disconnect and reconnect the power cord,
and retry updating.
Limitation of liability
The program and accompanying online
documentation are furnished to you for use at your
own risk. Our company will not be liable and you will
have no remedy for damages for any claim of any kind
whatsoever concerning your use of the program or the
accompanying online documentation, regardless of
legal theory, and whether arising in tort or contract. In
no event will our company be liable to you or any third
party for any special, indirect, incidental, or
consequential damages of any kind, including, but not
limited to, compensation, reimbursement or damages
on account of the loss of present or prospective
profits, loss of data, or for any other reason
whatsoever.
Precautions when updating the firmware
0 Confirm that the unit is on and connected to a
network.
0 Before starting an update, stop the Internet radio,
USB device, server or any other device that is
playing audio.
0 While updating, never disconnect or turn off this
unit.
0 While updating, never disconnect and reconnect
the Ethernet cable.
0 While updating, never disconnect and reconnect
the power cord.
0 Do not access this unit from a PC while updating.
0 Updating takes about 30 minutes to be completed.
0 Settings you made are retained after updating.
RETURN
NET
SETUP
ENTER
,
TX-8140_mst.book 36 ページ ２０１５年９月２９日 火曜日 午前１１時１３分