Instruction Manual

Firmware Update for the TX-NR3010 & TX-NR5010
#
#
L"/#("#C-)%'-)#(*)#G)."-5#M)3,2)#
#
#
W?#Download the zipped firmware update file and save to the Desktop of your computer:
http://download.onkyo.com/AVR000F/ONKAVR000F_HAHAHAHAHA00HA_111.zip
File name: ONKAVR000F_HAHAHAHAHA00HA_111
2. Right click on the file and select “Extract All” and place the extracted folder on the Desktop of your
computer.
3. Connect the USB Memory Device to the USB port of your computer and copy the contents only of the
unzipped/extracted folder onto your USB Memory Device.
4. Safely eject the USB Memory Device from your computer.
How to upgrade the firmware via the USB
1. Turn on the receiver and select the USB input, and wait for the “Now Initializing...” process to complete (35-
45 seconds).
2. Insert the USB Memory Device containing the software into the front panel USB port of the receiver
3. From the front panel press and hold the “USB” input button, followed by the “On/Standby” button. Unit will
display “Update <Enter>". Press Enter
4. Press the “Enter” button on the front panel to begin the update.
5. Do not shut the unit off until “Complete” is shown on the front display
6. Once the update has completed check the firmware version to confirm that the unit is fully up to date. If it is
not, run the update again.
To check the firmware version, press the “Home” button on the front panel or remote control. Highlight
“Hardware Setup” and press enter. Highlight “Firmware Update” and press enter. The current firmware version
will be displayed on the Firmware Update page.
Current firmware version: 1081-0104-0200-0000
#