Operation Manual

122
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
 6. Equalizer Settings
You can adjust the output volume of the range for each connected speaker.
Adjust the volume of different sound ranges for each speaker. You can set three
different equalizers in Preset 1 to 3. The number of frequencies that can be
selected for each speaker is up to ve bands for the Subwoofer and nine bands
for the other speakers.
Setting Item Default Value Setting Details
Front 0.0 dB
After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
Center 0.0 dB After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
Height 0.0 dB After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
• The setting cannot be changed if "Conguration" -
"Zone Speaker" is set to "Zone 2" and Zone 2 is on.
Surround 0.0 dB After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
Surround Back 0.0 dB After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
• The setting cannot be changed if "Conguration" -
"Zone Speaker" is set to "Zone 2" and Zone 2 is on.
Subwoofer 0.0 dB After selecting the speaker frequency between
"25 Hz" and "160 Hz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
• This cannot be selected if "Conguration" -
"Subwoofer" is set to "No".
• Depending on the input source or listening mode setting, the desired effect may not be
achieved.
 7. THX Audio
Change the THX Audio settings.
Setting Item Default Value Setting Details
Back Speaker
Spacing
>4.0 ft/>1.2 m Select the distance between the surround back
speakers from "<1.0 ft/<0.3 m", "1.0 - 4.0 ft/0.3 -
1.2 m", and ">4.0 ft/>1.2 m".
• The unit of distance (ft/m) is displayed using the
unit selected for the "Distance" setting.
• The setting cannot be changed if "Conguration"
- "Zone Speaker" is set to a selection item other
than "No" and Zone 2 is on.
• If the item cannot be selected even though
connection is correct, check if the setting in
"Conguration" - "Speaker Channels" matches
the number of connected channels.
THX Ultra / Select
Subwoofer
No Set whether a THX-certied subwoofer is
connected or not.
"Yes": When a THX-certied subwoofer is
connected
"No": When a THX-certied subwoofer is not
connected
• The setting cannot be changed if "Conguration"
- "Subwoofer" is set to "No"
BGC Off Correct an emphasized bass sound when listening
to music near the wall or boundary of the room due
to layout limitation of the listening room. The THX
Select receivers can adjust the balance of bass
sound.
"On": When this function is used
"Off": When this function is not used
• In the following cases, the setting cannot be
changed:
– "Conguration" - "Subwoofer" is set to "No".
– "THX Ultra / Select Subwoofer" is set to "No".