User Manual

Initial Setup

Initial Setup with Auto Start-up Wizard

Initial Setup Starts Automatically

When you turn the unit on for the first time after purchasing

it, Initial Setup is automatically shown on the TV to enable

you to make settings required for startup using simple

operations following onscreen guidance.

1. Switch the input on the TV to that assigned to the unit.

2. Put batteries into the remote controller of this unit.

3. Press Í on the remote controller to turn the unit on.

4. Select the item with the cursors of the remote controller

and press ENTER (a) to confirm your selection. To return

to the previous screen, press (b).

0 If you terminate the procedure on the way or want to

change a setting made during Initial Setup, press on

the remote controller, select "7. Miscellaneous" – "Initial

Setup", and press ENTER.

∫ 1. AccuEQ Room Calibration

Place the supplied speaker setup microphone in the listening position,

measure the test tones emitted by the speakers, then the unit

automatically sets the optimum volume level for each speaker, the

crossover frequencies, and the distance from the listening position. This

also automatically adjusts the equalizers for the speakers and enables

correction of distortion caused by the acoustic environment of the room.

Calibration takes between 3 and 12 minutes to be

completed. The speakers emit the test tone at high volume

during measurement, so be careful of your surroundings.

> Before Start > Part Names > Install > Initial Setup > Playback > Advanced Manual

Troubleshooting | Supplementary Information, etc.

2 3

INPUT