Owner's Manual

Advanced Settings
27
2.Speaker Setup
Allows you to change the speaker configuration such as presence or not of subwoofer,
crossover frequency, and so on. Settings are automatically configured if you use the
Automatic Speaker Setup.
Furthermore, this setting cannot be selected if headphones are connected or audio is
output from the speakers of the TV.
Speaker Settings
Change the impedance of the connected speakers, the type of front speaker connection,
and other speaker settings.
Setting Item Default Value Setting Details
Speaker
Impedance
6ohms Set the impedance of the connected speakers.
"4ohms": When any of the connected speakers have
4Ωormoretolessthan6Ωimpedance
"6ohms":Whentheconnectedspeakersallhave6Ω
or more impedance
Front Speakers
Type
Normal Select the type of front speaker connection.
"Normal": When front speakers are connected in a
normal manner
"Bi-Amp": When front speakers are bi-amp
connected
Powered Zone 2 No Set presence of speaker terminal connection of
Zone 2
"Yes": When speakers are connected to ZONE 2
speaker terminals
"No": When speakers are not connected to ZONE 2
speaker terminals
•
If "Front Speakers Type" is set to "Bi-Amp", this
setting will be set to "No".
•
For impedance, check the indications on the back of the speakers or their instruction manual.
Speaker Configuration
Allows you to change the speaker configuration such as presence or not of each speaker,
crossover frequency, and so on. Settings are automatically configured if you use the
Automatic Speaker Setup. Audio will not be output while you are making this setting.
Setting Item Default Value Setting Details
Subwoofer Ye s Set whether a subwoofer is connected or not.
"Yes": When subwoofer is connected
"No": When subwoofer is not connected
Front 80Hz(THX) Select the crossover frequency from "40Hz" to
"200Hz" to start outputting bass frequencies for
each channel.
"Full Band": Full band will be output.
"None": When no compatible speaker is connected
•
"Front" will be fixed to "Full Band" if "Subwoofer"
is set to "No", and the bass frequencies of the
other channels will be output from the front
speakers. To make the settings, refer to the
instruction manual of the speakers used.
Center 80Hz(THX) Select the crossover frequency from "40Hz" to
"200Hz" to start outputting bass frequencies for
each channel.
"Full Band": Full band will be output.
"None": When no compatible speaker is connected
•
"Full Band" cannot be set unless "Front" is set to
"Full Band".
Surround 80Hz(THX) Select the crossover frequency from "40Hz" to
"200Hz" to start outputting bass frequencies for
each channel.
"Full Band": Full band will be output.
"None": When no compatible speaker is connected
•
"Full Band" cannot be set unless "Front" is set to
"Full Band".