Operation Manual

Advanced Settings
28
Setting Item Default Value Setting Details
Surround 80Hz(THX) Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
"None": When no compatible speaker is connected
r
"Full Band" cannot be set unless "Front" is set to
"Full Band".
Back 80Hz(THX) Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
"None": When no compatible speaker is connected
r
In any of the following cases, this setting will be
set to "None".
– "Surround" is set to "None".
– "Speaker Settings" - "Front Speakers Type" is
set to "Bi-Amp".
– "Speaker Settings" - "Height Speakers Type" is
set to other than "Not Use".
– "Speaker Settings" - "Powered Zone 2" is set
to "Yes" and also Zone 2 is set to on.
r
"Full Band" cannot be set unless "Surround" is
set to "Full Band".
Back ch 2ch Select the number of channels of the connected
surround back speaker.
"1ch": When one speaker is connected (Connect to
the BACK L terminal)
"2ch": When two speakers are connected
r
The setting cannot be changed if "Back" is set to
"None".
Setting Item Default Value Setting Details
Wide None Select the crossover frequency from "40Hz" to
"200Hz" to start outputting bass frequencies for
each channel.
"Full Band": Full band will be output.
"None": When no compatible speaker is connected
r
In any of the following cases, this setting will be
set to "None".
– "Surround" is set to "None".
– "Speaker Settings" - "Front Speakers Type" is
set to "Bi-Amp".
– "Speaker Settings" - "Powered Zone 2" is set
to "Yes".
r
"Full Band" can only be set if "Front" is set to "Full
Band".
Height None Select the crossover frequency from "40Hz" to
"200Hz" to start outputting bass frequencies for
each channel.
"Full Band": Full band will be output.
r
In any of the following cases, this setting will be
set to "None".
– "Speaker Settings" - "Front Speakers Type" is
set to "Bi-Amp".
– "Speaker Settings" - "Height Speakers Type" is
set to "Not Use".
– "Speaker Settings" - "Powered Zone 2" is set
to "Yes" and also Zone 2 is set to on.
r
If any type is selected in "Speaker Settings" -
"Height Speakers Type", this setting will be set to
"80Hz(THX)" as default value. In this case, this
setting cannot be set to "None".
r
"Full Band" can only be set if "Front" is set to "Full
Band".
LPF of LFE 120Hz Set the low-pass filter for LFE (low-frequency effect)
signals in order to pass lower frequency signals than
the set value and thus cancel unwanted noises. The
low-pass filter will be effective only on sources with
LFE channel.
Set a frequency from "80Hz" to "120Hz".
"Off": Do not use this function