Operation Manual

3
> Specifications > Settings > Listening Modes > Playback Function > Basic Manual
Troubleshooting | Appendix
General Specifications
■ Amplifier Section
Rated Output Power (FTC) (North American)
With 8 ohm loads, both channels driven, at 1 kHz;
rated 140 watts per channel minimum RMS power,
with no more than 0.08% total harmonic distortion
from 250 milliwatts to rated output.
Surround Mode Output Power (＊)
(6 ohms, 1 kHz THD 0.9%) 200 W per channel
＊ Reference output for each speakers.
Depending on the source and the listening mode
settings, there may be no sound output.
Rated Output Power (IEC) (Others)
9 ch × 200 W at 6 ohms, 1 kHz, 1 ch driven of 1%
THD
Maximum Effective Output Power (JEITA) (Asian and
Australian)
9 ch × 320 W at 4 ohms, 1 kHz, 1 ch driven of 10%
THD
Dynamic Power (＊)
＊ IEC60268-Short-term maximum output power
320 W (3 Ω, Front)
270 W (4 Ω, Front)
160 W (8 Ω, Front)
THD+N (Total Harmonic Distortion+Noise)
0.04% (1 kHz, 100 W)
Input Sensitivity and Impedance (1 kHz, 100 W/8 Ω)
200 mV/82 kΩ (LINE (Unbalance))
3.5 mV/47 kΩ (PHONO MM)
Rated RCA Output Level and Impedance
1 V/330 Ω (PRE OUT)
1 V/330 Ω (SUBWOOFER PRE OUT)
200 mV/1.2 kΩ (ZONE LINE OUT)
2 V/1.2 kΩ (ZONE PRE OUT)
Phono Overload
70 mV (MM 1 kHz 0.5%)
Tone Control Characteristics
±10 dB, 100 Hz (BASS)
±10 dB, 10 kHz (TREBLE)
Signal to Noise Ratio
108 dB (IHF-A, LINE IN, SP OUT)
90 dB (IHF-A, PHONO IN, SP OUT)
Speaker Impedance
4 Ω - 16 Ω
Headphone Output Impedance
43 Ω
Headphone Rated Output
57 mW (32 Ω, 1 kHz, 10% THD)
■ Video Section
Signal level
1 Vp-p/75 Ω (Composite Video)
1 Vp-p/75 Ω (Component Video Y)
0.7 Vp-p/75 Ω (Component Video PB/PR)
Maximum resolution supported by component video
1080i (＊)
＊ When output from HDMI, only 480i/576i resolution
input is possible.
■ Tuner Section
FM Tuning Frequency Range
87.5 MHz - 107.9 MHz (North American)
87.5 MHz - 108.0 MHz, RDS (Others)
AM Tuning Frequency Range
530 kHz - 1710 kHz (North American)
522/530 kHz - 1611/1710 kHz (Others)
Preset Channel
40
■ Network Section
Ethernet LAN
10BASE-T/100BASE-TX
Wireless LAN
IEEE 802.11 a/b/g/n standard
(Wi-Fi
R
standard)
5 GHz/2.4 GHz band
■ BLUETOOTH Section
Communication system
BLUETOOTH Specification version 4.1+LE
Frequency band
2.4 GHz band
Modulation method
FHSS (Freq Hopping Spread Spectrum)
Compatible BLUETOOTH profiles
A2DP 1.2
AVRCP 1.3
HOGP-Host (Client)
HOGP-HID Device (Server)
HID Service (HIDS)
Supported Codecs
SBC
AAC
Transmission range (A2DP)
20 Hz - 20 kHz (Sampling frequency 44.1 kHz)
Maximum communication range
Line of sight approx. 15 m (＊)
＊ The actual range will vary depending on factors
such as obstacles between devices, magnetic fields
around a microwave oven, static electricity, cordless
phone, reception sensitivity, antenna's performance,
operating system, software application, etc.
■ General
Power Supply
AC 120 V, 60 Hz (North American)
AC 220 - 230 V, 50/60 Hz (European, Australian and
Chinese)
AC 220 - 230/240 V, 50/60 Hz (Others)
Power Consumption
320 W
0.15 W (Stand-by, North American)
0.2 W (Stand-by, Others)
100 W (No-sound)
6 W (HDMI Standby Through)
2.5 W (Network Standby)
Dimensions (W × H × D)
435 mm × 201 mm × 453 mm