Owner's Manual

110
Playback
Playing Back (ZONE 3)
In remote controller operation, while pressing and holding the ZONE 3 SHIFT
button, press other buttons for operation. Settings are required to playback a
source in ZONE 3.
When outputting from the speakers: Set "2. Speaker" - "Conguration" -
"Zone Speaker" (
p132) in the Setup menu to "Zone 2/Zone 3".
When outputting from the integrated amplier: Set "2. Speaker" -
"Conguration" ( →p131) in the Setup, to one of the following.
– Set "Speaker Channels" to "2.1 ch", "3.1 ch", "4.1 ch", or "5.1 ch"
– Set "Speaker Channels" to "2.1.2 ch", "3.1.2 ch", "4.1.2 ch", or "5.1.2 ch", and
set "Bi-Amp" and "Zone Speaker" to "No"
1. While pressing and holding the ZONE 3 SHIFT button on the remote
controller, point the remote controller at this unit and press .
• "Z3" on the display of the main unit lights up.
2. While pressing and holding the ZONE 3 SHIFT button on the remote
controller, press the input selector of the input source you want to play in
the separate room. To control on the main unit, press the ZONE 3 button,
and then within 8 seconds, press the input selector button of the input to be
played in the separate room. To play the same source in the main room and
separate room, press the ZONE 3 button of the main unit twice.
3. While pressing and holding the ZONE 3 SHIFT button on the remote
controller, adjust the volume with the volume button. To do this on the main
unit, press the ZONE 3 button, and then within 8 seconds, adjust the volume
using the MASTER VOLUME dial.
• When connecting the power amplier set "6. Multi Zone" - "Zone 3" -
"Output Level" ( p153) to "Variable". If it is not set, a large volume is
output and the power amplier, speakers, etc. may be damaged.
• If you turn the unit to standby during multi-zone playback, the Z3 indicator is
dimmed, and the playback mode is switched to playback in a separate room
only. Setting ZONE 3 to on while the unit is in standby also switches the
playback mode to playback in the separate room only.
1
2