Operation Manual

100
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Switch remote control mode (ZONE 3)
At the time of purchase, the remote controller is in the mode to control playback
in the main room. Settings are required to playback a source in ZONE 3.
When outputting from the speakers: Set "2. Speaker" - "Conguration" - "Zone
Speaker" in the Setup menu ( p131) to "Zone 2/Zone 3", and set the remote
controller to ZONE control mode (ZONE 3). To operate the playback of the main
room again, it is necessary to return the remote controller to the main room
control mode.
When outputting from the integrated amplier or the power amplier: Set
"2. Speaker" - "Conguration" in the Setup ( p131) to one of the following,
and set the remote controller to ZONE control mode (ZONE 3). To operate the
playback of the main room again, it is necessary to return the remote controller to
the main room control mode.
– Set "Speaker Channels" to "2.1 ch", "3.1 ch", "4.1 ch", or "5.1 ch"
– Set "Speaker Channels" to "2.1.2 ch", "3.1.2 ch", "4.1.2 ch", or "5.1.2 ch", and
set "Bi-Amp" and "Zone Speaker" to "No"
1. While pressing and holding MODE, press ZONE 3 at least 3 seconds until the
remote indicator blinks three times.
• The mode of the remote controller switches to the mode to control ZONE 3.
• To restore the main room control mode, while pressing and holding MODE,
press MAIN at least 3 seconds until the remote indicator blinks once.
MAIN
MODE
Setting the main room control mode
ZONE 3
MODE
Setting the ZONE control mode
(ZONE 3)
Setting the ZONE
control mode (ZONE 3)
Setting the main room
control mode