Owner's Manual

17
> Network Functions > Specifications > Advanced Setup > Listening Modes
Troubleshooting Supplementary Information, etc�|
> Basic Manual
3� Audio Adjust
Make advanced settings such as those related to multiplex audio, settings for the LFE level,
or those related to the volume of this unit.
■ 1� Multiplex/Mono
Setting Item Default Value Setting Details
Multiplex Input
Channel
Main Set the audio channel or language to be output
when playing multiplex audio or multilingual TV
broadcasts etc.
"Main": Main channel only
"Sub": Sub channel only
"Main/Sub": Main and sub channels will be output
at the same time.
•
If multiplex audio is being played, "1＋1" will be
displayed when
on the remote controller is
pressed.
Mono Input
Channel
Left + Right Set the input channel to use for playing any 2 ch
digital source such as Dolby Digital, or 2 ch analog/
PCM source in the Mono listening mode.
"Left": Left channel only
"Right": Right channel only
"Left + Right" : Left and right channels
Mono Output
Speaker
Center Select the speaker to output monaural audio in the
Mono listening mode.
"Center": Audio is output from the center speaker.
"Left/Right": Audio is output from the front L/R
speakers.
•
If an item cannot be selected even though
connection is correct, check that the settings
in "2. Speaker" - "Configuration" - "Speaker
Channels" matches the number of connected
channels.
■ 2� Dolby
Setting Item Default Value Setting Details
Loudness
Management
On When playing Dolby TrueHD, enable the dialog
normalization function which keeps the volume of
dialog at a certain level. Note that when this setting
is Off, the Late Night function that allows you to
enjoy surround at low volumes is fixed to off when
playing Dolby Digital Plus/Dolby TrueHD.
"On": When this function is to be used
"Off": When this function is not to be used
■ 3� DTS
Setting Item Default Value Setting Details
DTS Auto
Surround
On When inputting DTS signals that include extended
channel information, the optimum listening mode is
automatically selected according to the extended
information contained in the input signal and the
speaker configuration of this unit when playing in
the straight decoding listening mode.
"On": Use this function
"Off": Audio is played using the same amount
of channels in the input signal according to the
speaker configuration of this unit.
•
The ES Matrix and ES Discrete listening modes
cannot be selected if this function is set to "Off".
■ 4� LFE Level
Set the low-frequency effect (LFE) level for Dolby Digital series, DTS series, Multichannel
PCM, and DSD signals.
Setting Item Default Value Setting Details
LFE Level 0dB Select the low-frequency effect (LFE) level of each
type of signal from "0dB" to "−󲰄dB". If the low-
frequency effect sound is too strong, select
"−20dB" or "−󲰄dB".