Operation Manual

Advanced Settings (Setup Menu)
En-44
3. Audio Adjust
Configure various settings related to sound, such as settings for listening to multiplex audio
or multilingual TV broadcasts and sound field settings for listening modes.
Multiplex/Mono
Setting Item Default Value Setting Details
Multiplex
Input Channel
Main Set the audio channel or language to be output
when playing multiplex audio or multilingual TV
broadcasts etc.
"Main": Main channel only
"Sub": Sub channel only
"Main/Sub": Main and sub channels will be
output at the same time.
● If multiplex audio is being played, "1+1" will
be displayed when DISPLAY is pressed.
Mono
Input Channel
Left+Right Set the input channel to use for playing any 2
ch digital source such as Dolby Digital, or 2-ch
analog/PCM source in the Mono listening mode.
"Left": Left channel only
"Right": Right channel only
"Left + Right" : Left and right channels
Mono
Output
Speaker
Center Select the speaker to output monaural audio in
the Mono listening mode.
"Center": Audio is output from the center
speaker.
"Left/Right": Audio is output from the front L/R
speakers.
● If an item cannot be selected even though
connection is correct, check that the settings
in "Configuration" - "Speaker Channels"
matches the number of connected channels.
Dolby
Make the settings for Dolby listening mode.
Setting Item Default Value Setting Details
Loudness
Management
On Enable the Late Night function that allows
you to enjoy surround sound of Dolby TrueHD
playback even in low volume.
"On": Use this function
"Off": Do not use this function
Theater-Dimensional
Make the settings for Theater-Dimensional listening mode.
Setting Item Default Value Setting Details
Listening Angle Wide To enhance the effect of Theater-Dimensional,
select the actual angle of the left and right
front speakers as it appears from the listening
position.
"Narrow": Less than 30°
"Wide": Greater than 30°
● Position the front speakers 20° to the listening position if you have selected "Narrow" in "Listening
Angle" and 40° if you have selected "Wide".
LFE Level
Set the low-frequency effect (LFE) level of the Dolby Digital, DTS, Multichannel PCM and
DSD signals.
Setting item Default Value Setting Details
Dolby D/Dolby D+/
TrueHD
0dB Select the low-frequency effect (LFE) level of
each type of signal from "0dB" to "-∞dB". If the
low-frequency effect sound is too strong, select
"-20dB" or "-∞dB".
DTS/DTS-ES/DTS-
HD
0dB Select the low-frequency effect (LFE) level of
each type of signal from "0dB" to "-∞dB". If the
low-frequency effect sound is too strong, select
"-20dB" or "-∞dB".
● This setting works on LFE channel volume of
DTS, DTS-ES, DTS-HD High Resolution and
DTS-HD Master Audio sources.