Operation Manual

Advanced Settings (Setup Menu)
En-45
Setting item Default Value Setting Details
Other Multich Source 0dB Select the low-frequency effect (LFE) level of
each type of signal from "0dB" to "-∞dB". If the
low-frequency effect sound is too strong, select
"-20dB" or "-∞dB".
● This setting works on LFE channel volume of
Multichannel PCM and DSD sources.
Volume
Make the detailed volume setting of the unit.
Setting Item Default Value Setting Details
Volume Display Absolute Switch the volume display between the absolute
value and relative value. The absolute value 82.0
is equivalent to the relative value 0.0dB.
"Absolute": Absolute value such as "0.5" to "99.5"
"Relative": Relative value such as "-81.5dB" and
"+18.0dB"
● If the absolute value is set to "82.0", "82.0Ref"
will appear on the display.
Muting Level -∞dB Set the volume lowered from the listening volume
when muting is on.
Select a value from "-∞dB", "-40dB" to "-20dB".
Maximum Volume Off Set the maximum value to avoid too high volume.
Select a value from "Off", "50" to "99". (When
"Volume Display" is set to "Absolute")
Power On Volume Last Set the volume level of when the power is turned
on. Select a value from "Last" (Volume level
before entering standby mode), "Min", "1" to "99"
and "Max". (When "Volume Display" is set to
"Absolute")
● You cannot set a higher value than that of
"Maximum Volume".
Headphone Level 0 dB Adjust the output level of the headphones.
Select a value between "-12 dB" and "+12 dB".
Multi Zone
Setting Item Default Value Setting Details
Zone 2 Out Fixed Select which of the integrated amplifier in a
separate room or this unit should be used to
adjust the volume when Zone 2 is active.
"Fixed": Adjust on the Integrated amplifier in a
separate room
"Variable": Adjust on the unit
Zone 2 Maximum
Volume
Off Set the maximum value for Zone 2 to avoid
too high volume. Select a value from "Off",
"50" to "99". (When "Volume Display" is set to
"Absolute")
Zone 2 Power On
Volume
Last Set the Zone 2 volume level of when the unit is
turned on. Select a value from "Last" (Volume
level when the unit was turned off), "Min", "1" to
"99" and "Max". (When "Volume Display" is set
to "Absolute")
● You cannot set a higher value than that of
"Zone 2 Maximum Volume".