User Guide
5
En
Rear Panel
1. COMPONENT VIDEO IN jacks: Input the AV component video signals with a component
video cable. (Compatible only with 480i or 576i resolution.)
2. ZONE 2/ZONE 3 PRE/LINE OUT jacks: Output audio signals with an analog audio cable
to a pre-main amplifier or power amplifier in a separate room (ZONE 2/ZONE 3).
3. HDMI IN jacks: Transmit video signals and audio signals with a HDMI cable connected to
an AV component.
4. VIDEO IN jacks: Input the AV component video signals with an analog video cable.
5. AUDIO IN jacks: Input TV or AV component audio signals with an analog audio cable.
6. GND terminal: The ground wire of the turntable is connected.
7. HDMI OUT jacks: Transmit video signals and audio signals with a HDMI cable connected
to a monitor such as a TV or projector.
8. ETHERNET port: Connect to the network with an Ethernet cable.
9. USB port: A USB storage device is connected so that music files stored in it can be
played. You can also supply power (maximum
5 V/1 A) to USB devices with a USB cable.
10.
DIGITAL IN OPTICAL/COAXIAL jacks: Input AV component digital audio signals with a
digital optical cable or digital coaxial cable.
11.
Wireless antenna: Used upright for Wi-Fi connection or when using a BLUETOOTH
enabled device. The diagram shows the movable range for the wireless antenna. Do not
try to force it beyond this range otherwise you may break it.
12.
AC INLET: The supplied power cord is connected.
13.
RS232 port: For connection to the home control system. (*)
14.
TUNER AM/FM 75≠ terminal: The supplied antennas are connected.
> Before Start >Part Names > Install > Initial Setup > Playback
(*)You can find details in the Advanced Manual.
SN29403079A_TX-RZ920_BAS_En_1711XX.book 5 ページ ２０１７年１０月２６日 木曜日 午後４時４６分