674E TX-SR8467

Advanced Setup—Continued

With this preference, you can protect your settings by

locking the setup menus.

When the setup menus are locked, you cannot change

any setting.

Locked: Setup menus locked.

Unlocked: Setup menus not locked.

The digital input signal formats are available only for the

input sources that you have assigned a digital input jack;

otherwise you will see “Analog” indicated on the screen

(see page 44).

Normally, the AV receiver detects the signal format auto-

matically. However, if you experience either of the fol-

lowing issues when playing PCM or DTS material, you

can manually set the signal format to PCM or DTS:

• If the beginnings of tracks from a PCM source are cut

off, try setting the format to PCM.

• If noise is produced when fast forwarding or reversing

a DTS CD, try setting the format to DTS.

Lock Setup

Press the [RECEIVER] button fol-

lowed by the [SETUP] button.

The main menu appears onscreen.

Use the Up and Down [ ]/[ ]

buttons to select “9. Lock Setup,”

and then press [ENTER].

RECEIVER

SETUP

9.Lock Setup

------------------------

a.Lock :Unlocked

Digital Input Signal Formats

Press and hold the AV receiver’s [DIGI-

TAL INPUT] button for about 3 seconds.

While “Auto” is displayed (about 3 sec-

onds), press the [DIGITAL INPUT] button

again to select: PCM, DTS, or Auto.

DTS or PCM: The DTS or PCM indicator,

depending on which format you have set, ﬂashes,

and only signals in that format are output. Digital

signals in other formats are ignored.

Auto (default): The format is detected automat-

ically. If no digital input signal is present, the cor-

responding analog input is used instead.

DIGITAL INPUT