Manual

115
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Playing Back (ZONE 2)
In remote controller operation, while pressing and holding the ZONE 2 SHIFT
button, press other buttons for operation.
1. While pressing and holding the ZONE 2 SHIFT button on the remote controller,
point the remote controller at this unit and press .
• "Z2" on the display of the main unit lights up.
2. While pressing and holding the ZONE 2 SHIFT button on the remote controller,
press the input selector of the input source you want to play in the separate
room. To control on the main unit, press the ZONE 2 button, and then within
8 seconds, press the input selector button of the input to be played in the
separate room. To play the same source in the main room and separate room,
press the ZONE 2 button of the main unit twice.
3. If the unit is connected to the pre-main amplier in the separate room, adjust
the volume on the pre-main amplier. If the unit is connected to the power
amplier or ZONE speaker in the separate room, adjust the volume with the
volume button while pressing and holding the ZONE 2 SHIFT button on the
remote controller. To do this on the main unit, press the ZONE 2 button, and
then within 8 seconds, adjust the volume using the MASTER VOLUME dial.
• When connecting the power amplier set "6. Multi Zone" - "Zone 2" -
"Output Level" ( p174) to "Variable". If it is not set, a large volume is
output and the power amplier, speakers, etc. may be damaged.
• The sound quality of the power amplier connected in the separate room
can also be adjusted. Press the ZONE 2 button of this unit, and then press
the TONE button within 8 seconds. Then turn the TONE dial for adjustment.
• Information of a connected device can be displayed on the TV in the
separate room. Press the
button while pressing and holding the ZONE 2
SHIFT button on the remote controller.
• If you turn the unit to standby during multi-zone playback, the Z2 indicator is
dimmed, and the playback mode is switched to playback in a separate room
only. Setting ZONE 2 to on while the unit is in standby also switches the
playback mode to playback in the separate room only.
• The audio from externally connected AV components can be output to ZONE
2 only when the audio is analog or 2ch PCM signal. When the AV component