J20C Robot cleaner user guide manual MODEL: J20C Email: customer@onson.shop Telephone: 1-855-919-0908 Adress: 1601, Building 2, No.
Safety Instructions • To reduce the risk of damage, please keep in mind the following safety precautions when resetting, using and maintaining the product: • Please read all safety and operation instructions before using this product. • Please preserve the instructions for future use. • Please note all warnings in the instructions regarding the product, battery, charging dock. • Follow all instructions and instructions.
• Before using this product, please tidy up items such as clothes, pieces of paper, hanging curtains or curtains, power source cords and any fragile items.If the product goes over a wire and drags it, it may pull an object off a table or shelf. • If there is such an environment as a balcony, a protective fence should be set on the edge of the balcony to prevent products from entering the balcony and ensure safe work. • Do not place anything on top of the product.
1.2 Other components of the product 1.4 Remote control Module and time indication screen Charging dock Adapter Remote control Recharging Auto clean Direction and time setting Start/pause Clock setting Dust box Rolling brush Cleaning brush 4xSide brush Filter sponge and high efficiency filter Boundary Strips 6.6 ft/2 m Length (x2) 1.
Product useage Activate product Place robot onto the Charging Dock, making sure the metal charging contacts on the Charging Dock match up with those underneath the Robot. If successful you will hear a series of tones. once the Power button illuminates robot is ready for use 2.1 Quick start Connect the charging dock to the cable storage box at the bottom of the charging dock. Start cleaning • Press once to wake up the Warm tips: Uncollected cables may trap the cleaner that is cleaning or recharging.
Fixed point cleaning Setting Cleaning Schedule Fixed point sweep the fixed point sweep mode is selected. The cleaner concentrates on sweeping the partially local area by rotating outwardly in a spiral with a diameter of about 1m, and then spirals inwards to the starting point.Under this mode, the cleaner increases suction, giving you the best cleaning of the desired location.Please put the cleaner in a dirty place and press the remote control .
3.1 Empty dust box Press the dust box Release button to remove it. 2. Remove the cover of the dust box and empty it. 4 Use a cleaning brush to clean the universal wheel. 5 Dust the sensor with a cleaning brush to ensure optimum performance. 3.2 Cleaning filter Pull on the white label and remove the filter Shake the garbage off the filter. Note: please pay attention when cleaning the cleaner. If there is too much dust or oil on the optical flow sensor sleeve, do not wipe it with your finger.
4. lamp effect and alarm indication lamp effect indication Operation indication light Sleep mode WIFI indication lamp remark Non light indication WIFI Standby mode No light indication Link constant on/ disconnect flicker Standby mode Main push key blue lamp on Link constant on/ disconnect flicker Work mode Main push key blue lamp constant on Recharging mode Low power recharging: the purple light of the cleaner key is always on.
No. 1 Malfunction The cleaner could not recharge Possible cause Solution There is insufficient contact Make sure the charging poles of the cleaner and charging dock fully connected. When the cleaner is not The power supply of the charging dock performing work, it is recommended that it will be has been turned off, and the power maintaining the charging switch of the cleaner has been turned status, so as to better on.It leads to power loss. proceed to the next work task.
