User Manual

- 10 -
• Collect the cables you want to connect to the unit Se below).Pull
the cables through the screw cap.
• Connect the cables:
a. Power. Terminal A. 12VDC. Either the power adapter or an 12V
accumulator or both. Plus (white cord) is connected to con-
nector “+12-24VDC”. Minus (black cord) is connected to the
connector ”GND . Important. Do not connect to power at this
stage. It can damage the equipment.
b. Relay. Terminal B. If you want “Normally Open Relay” (use
connector 2 and 3. If you want “Normally Closed Relay” (use
connector 1 and 3. Maximum load is 230V/10A .
NB. If you shall connect main power, contact a professional
electrician.
c. Alarm. Terminal A. Alarm A is connected to connector “3.8V”
and “A” and alarm B is connected to connector ““3.8V” ” and “B”.
See g 2 and 3.
d. External temperature sensor. Terminal A. The sensor is con-
nected to connector “Temp” and “GND”.
e. Adapter for GPS-receiver (page 23). Contact D. Connect the
connector.
• Whenalldesiredcableshavebeenconnected,turnthescrewcap
clockwise in order to create a tight seal. You can use plastic tape
around the bundle of cables to make it thicker and that way create
a tighter seal.
• Push the ”hood” back to its original position and replace the screws
and also the screw on top of the hood.
• Connect the power cable to the accumulator and/or the power
adapter to the mains.
• The green lamp starts to ash for about 20 seconds. This indicates
that the unit is searching and when the light is steady the unit is
connected to an GSM.
Set the PASSWORD
• Insert the SIM-card on the side of Ontech GSM 9025. Push it
until there is a click. See g. 1 how to orient the SIM-card.
• Insert the unit to a power socket and make sure the text on
the front is correct orientated. The green lamp starts to blink.