User Manual

- 12 -
The push button
Pushing the button activates or deactivates the relay. If an alarm is not
conrmed, the rst push conrms the alarm.
Hold down the button for 10 seconds until both lamps are turned o,
and the unit will power down if it is powered by the internal battery and
not connected to the power socket.
The lamps
The green lamp indicates connection with the GSM network. Flashing
green indicates searching for GSM network.
Red lamp is turned on when the relay is activated. It ashes when there
is an alarm active and not conrmed.
Alarm SMS / Status SMS
WhenyoureceiveanAlarmSMSorwhenyouhaverequestedaStatus
SMS it will contain all or some of the information below:
Example Explanation
*Ontech9025
Ver 33
Asterisk (*) means alarm function is activated. Ver. indicates
software version
Alarm:
1ab;3b Indicates all alarms that have been activated since the last
acknowledge. The number indicates the units ID number,
Ontech 9025 is always no 1, and the others refer to the
extra units or wireless alarm detectors connected.
Note that these inputs cannot send an alarm before the
alarm has been acknowledged.
Inttemp,
Exttemp
Indicates a temperature alarm, from internal sensor or
external sensor.
Inputs:
1b Indicates the alarm input that still is activated. In this
example the SMS means that inputs 1a, 1b and 3b has been
activated since the last acknowledge and that input 1b is
still activated.
Units: