User's Manual

Page: 18 of 19
To OEM installer:
1. FCC ID label on the final system must be labeled with "Contains FCC ID: XFT-TELOMD15" or
"Contains transmitter module FCC ID: XFT-TELOMD15 ".
2. In the user manual, final system integrator must be ensured that there is no instruction provided in
the user manual to install or remove the transmitter module.
3. Transmitter module must be installed and used in strict accordance with the manufacturer is
instructions as described in the user documentation that comes with the product. This device complies
with the following radio frequency and safety standards.
The user manual of the final host system must contain the following statements:
USA-Federal Communication Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class B Digital Device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction, may cause
harmful interference to radio communication. However, there is no grantee that interference will not
occur in a particular installation. If this equipment dose cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.