Operation Manual

Instruments, controls 71
r
Park pilot 3
Illuminates in yellow when ignition is
switched on, then extinguishes.
If it stays illuminated while driving, there is
a fault in the system - see page 142.
5
DCS (Descent Control System)
Both control indicators illuminate when
ignition is switched on, then extinguish.
Green
; illuminates when DCS is ready for
operation. Flashes during driving when
DCS is in operation, after pressing the
DCS button.
Yellow
; flashes to indicate system is not
ready for conditions to operate.
Illuminates to indicate there is a fault in the
system.
If the yellow control indicator flashes or
illuminates during driving, friction material
needs to cool down: drive the vehicle
without braking as much as possible.
Further information - see page 138.
B
AWD (All Wheel Drive)
Illuminates in yellow when ignition is
switched on, then extinguishes.
If it flashes during driving, the AWD system
is temporarily disabled.
If it illuminates, there is a fault in the
system. Consult a workshop as soon as
possible.
Further information - see page 121.
7
ESC Active & Warning
(Electronic Stability Control)
see page 136.
A
ESC Not Ready
see page 136.
J
ESC OFF
see page 136.
q
Automatic headlamp range
adjustment 3
Illuminates in yellow when ignition is
switched on, then extinguishes.
Comes on during driving to indicate a fault
that requires immediate attention. Consult
a workshop as soon as possible.
Further information - see page 97.
W
Coolant temperature
Illuminates in red when ignition is
switched on, then extinguishes.
If it illuminates when the engine is running
:
stop vehicle and switch off engine. Coolant
temperature is too high; danger of engine
damage. Check coolant level.
Further information - see page 195.
9 Warning
Allow engine to cool down before
removing coolant filler cap.
Back to overview