User's Manual

10
Pairing and Connecting A1 with Bluetooth Devices
Function Action / Tone Indicator Display
Pairing Mode
To put A1 in pairing mode, while pressing
MFB, slide Power Switch from x to o.
Keep pressing the MFB until you see
‘Wait for Pairing’, sonorix A1 and
Bluetooth Device Address. A1 is now
ready to be paired. Pairing mode lasts for
3 minutes, after this period A1 returns to
standby mode.
Wait for Pairing
sonorix A1
00150E001A05
Pairing Successful
&
Connection State
From a Bluetooth phone or PC, search for
sonorix A1. When prompted for pinkey,
enter ‘0000’ which is the pinkey for A1.
When paired, you will see ‘Pairing
Success’ followed by display of
‘Connection States’ and ‘Battery Level
Indicator.
If A1 was paired in upside down
position(Car Handsfree mode), car icon
will be displayed and likewise, if it was
paired in upright position(Speakerphone
mode), then the sound icon will be
displayed.
Pairing Success
In idle mode, short click MFB to check the
connection status. If Bluetooth icon is
highlighted, it means A1 is in connection
state.
Connection State
Under the following circumstance, A1
automatically attempts to reconnect to the
last connected device.
- When car engine is started
(when engine vibration has been
detected)
For any reasons, if A1 is disconnected,
long click MFB until you hear the beep
tone followed by display of
Connecting...’image. A1 will then
reconnect to the last device used.
Reconnect Function
Connecting…
Button Hold
Function
To prevent accidental button activation
while the device is being carried around,
lock the button operations by long clicking
MUTE/HOLD button. To unlock, long click
MUTE/HOLD button.