Installation Instructions
v. From the Add ACU Expansion Board dropdown, select Openpath
SDC and click Add.
● Note: You must add at least one expansion board
vi. A description of the SDC will appear in green. Click Save.
vii. At this point, you can create Readers, Entries, and Zones prior to
provisioning
b. To add multiple SDCs:
i. Go to https://control.openpath.com/login and log in
ii. Go to Administration > Quick Start
iii. Enter a Site Name, click Next
iv. Enter how many SDCs are located at your Site, then enter names
for the SDCs. Names are usually relevant to the location where
the SDC is installed. Click Next.
v. Enter how many Readers are connected to the ACUs and enter
names. Click Next.
vi. Review your Site Details, then click Confirm & Submit. It may take
a few minutes for setup to complete.
2. When you’re ready to provision, log into the Open Admin app with your Control
Center credentials
a. Locate the org to which you’re provisioning hardware, either on the list
or using search, then tap on the org name
b. Wait until the Status LED is solid blue, then press the Admin button
(Figure 3) on the SDC (the Status LED will change to blinking purple)
c. In the Open Admin app, tap on the last four digits of the serial number
for the SDC (the Status LED will change to solid purple)
d. Tap Provision Device
e. Tap on the ACU Name that you want to provision to (this is the name of
the SDC you created in the Control Center), then tap Yes to proceed
(the Status LED will change to blinking yellow)
f. The app will send notifications when the SDC provision state changes
from Unprovisioned to Provisioning in progress and Provisioning in
progress to Provisioning complete
g. When setup is complete, the Status LED will change to solid white
i. Note: SDC will disconnect from the Open Admin app after 5
minutes of inactivity; press the Admin button to reset the timer
Version 1
©
Openpath 2020
Page 9