Installation Instructions
COUNTRY SETTINGS
The country code on the SDC is automatically set up during initial connection and
provisioning based on information from the installer’s Open Admin app. This setting
cannot be changed by the installer. If you need to change the country code, please
contact Openpath support.
Troubleshooting
LEGACY WIRING
SDC LEDS
RESETTING THE SDC
LEGACY WIRING
Sometimes legacy wiring (unshielded and straight through, rather than shielded
twisted pair, often 22-6) results in slower connections and dropped packets between
the Openpath Reader and SDC. To remedy this, you can switch GND and VIN with +B
and -A connections on the SDC and readers to ensure the data pair (+B and -A) are
using the alternate pair of legacy wires.
SDC LEDS
The Openpath SDC’s Status LED indicates the following:
● Solid White indicates the SDC is provisioned and functioning normally
● Blinking Red indicates there is a problem with the Internet connection
● Solid Cyan appears when the SDC is booting
● Solid Yellow appears when you turn on the SDC for the first time
● Blinking Yellow
● Solid Blue indicates that the SDC has finished booting and is ready for
provisioning
● Solid Purple indicates that the SDC is connected to the Open Admin app
● Blinking Purple indicates the SDC is ready to connect to the Open Admin app
● Solid Red indicates the SDC is in an error state–go to the Hardware Dashboard
in the Control Center for more information
Version 1
©
Openpath 2020
Page 11