Installation Instructions


RESETTING THE SDC
SOFT RESET
To soft reset the SDC, disconnect power and Ethernet from the SDC, wait 10 seconds,
then reconnect the power.
HARD RESET
WARNING: Only hard reset the SDC if absolutely necessary and if instructed by
Openpath. This will clear all of the data off of the SDC and will require
reprovisioning.

To hard reset the ACU:
1. Disconnect power and Ethernet from the SDC
2. Hold down the ADMIN BUTTON for 15 seconds
3. While still holding down the ADMIN button, reconnect the power, and continue
to hold the button for another 15 seconds. You should see the Status LED turn
yellow.
4. Wait until the Status LED turns blue (refer to SDC LEDS) before PROVISIONING THE
ACU


 

Version 1
©  Openpath 2020
Page 13
