Installation Instructions

Installation Instructions for

Follow enclosed supplement installation instructions for electrical and fixture installation onto junction box.

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing NEC compliant junction

boxes.

This product is safety listed for damp locations.

Incandescent lamps may be dimmed with a standard incandescent dimmer.

LED LEDlamps may be dimmed with a dimmer. Consult lamp manufacturer for

additional information.

Chandelier

CAUTION RISK OF FIRE-

This product must be installed in accordance with the

applicable installation code by a person familiar with the

construction and operation of the product and the hazards

involved.

Use minimum 90°c supply conductors.

LAMP

SHADE

CANDLE

TUBE

CANDLE

FOLLOWER

LAMP

GASKET

Chandelier

Install the candle followers by placing them on top of the candle tubes. Screw the lamps into the sockets.

Refer to the label on the lamp socket for Max Wattage information.

Install the candle tubes by sliding them over the sockets.

Install the gasket over the socket and onto the shade base, then install the shade by screwingit into the shade base.

Repeat for remaining shades.

PAGE 1
Installation Instructions for Chandelier Chandelier GENERAL PRODUCT INFORMATION: CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is safety listed for damp locations. Incandescent lamps may be dimmed with a standard incandescent dimmer.
PAGE 2
MISE EN GARDE - RISQUE D'INCENDIE Ce produit doit être installé selon le code d’installation pertinent , par une personne qui connaÎt bien le produit et son fonctionnement ainsi que les risques inhérents Les fils d’alimentation doivent convenir pour 90°c. 1A 5 4 ABAT-JOUR 3 AMPOULE 2 SUIVEUR DE BOUGIE JOINT 3 1 2 AMPOULE 1 TUBE DE BOUGIE Installez les tubes de bougie en les glissant sur les douilles. Installez les bougeoirs en les plaçant sur les tubes des bougies.
PAGE 3
ADVERTENCIA - RIESGO DE INCENDIO Este productor debe ser instalado segun el codigo de instalacion aplicable por una persona que conozca la constussion y el funcionamiento del producto y los riesgos que supone. Conductores de alimentacion 90°c Min. 1A 5 4 PANTALLA 3 BOMBILLA 2 SEGUIDOR DE VELA JUNTA 3 1 BOMBILLA 1 TUBO DE VELA Instale los tubos de la vela deslizando sobre los enchufes. 2 Instale los seguidores de las velas colocándolos encima de los tubos de la vela.
PAGE 4
SAVE THESE INSTRUCTIONS! 4