Operation Manual

V 2.17t1
Oplink Communications, Inc.
To install the sensors:
1. Install the battery.
2. Attach the double-
sided tape onto the backs of the units
3. Door/Window
a. On your door:
i.
After selecting a location on the door, preferably on the edge of the door
away from the hinges, the large
the immovable frame of the door.
ii.
Place the small unit on the movable door with the small
the top half of the large unit
of a pencil or a quarter of an inch be
performance.
b. On your window:
i.
After selecting a location on the window, the large unit of the sensor
should be placed on the immovable window frame.
Oplink Communications, Inc.
Sensor DWM1301 Installation
sided tape onto the backs of the units
.
After selecting a location on the door, preferably on the edge of the door
away from the hinges, the large
unit of the sensor should be placed on
the immovable frame of the door.
Place the small unit on the movable door with the small
unit
the top half of the large unit
and not exceeding the recommended width
of a pencil or a quarter of an inch be
tween the sensors for best
performance.
After selecting a location on the window, the large unit of the sensor
should be placed on the immovable window frame.
13
After selecting a location on the door, preferably on the edge of the door
unit of the sensor should be placed on
unit
aligned near
and not exceeding the recommended width
tween the sensors for best
After selecting a location on the window, the large unit of the sensor