Operation Manual

V 2.17t1
Oplink Communications, Inc.
ii.
Place the small unit on the movable window with the small
near the t
op half of the large
width of a pencil or a quarter of an inch between the sensors for best
performance.
4.
When you open and close the doors and windows, the two parts should separate when
opened and then come back together when closed.
*Note: If your door
or window do
sensor on the frame, it is
acceptabl
make the placing easier
. This is an acceptable approach to sens
should only be used
when necessary.
Warning:
Do not dispose of electrical appliances as unsorted municipal waste. Use separate collection
facilities.
Contact your local government for information regarding the collection systems
available.
Oplink Communications, Inc.
Place the small unit on the movable window with the small
op half of the large
unit and not exceeding the recommended
width of a pencil or a quarter of an inch between the sensors for best
performance.
When you open and close the doors and windows, the two parts should separate when
opened and then come back together when closed.
or window do
es not allow you to properly place the large
unit
acceptabl
e to place the smaller unit of the sensor o
n the frame to
. This is an acceptable approach to sens
or
placement, although it
when necessary.
Do not dispose of electrical appliances as unsorted municipal waste. Use separate collection
Contact your local government for information regarding the collection systems
14
Place the small unit on the movable window with the small
unit aligned
unit and not exceeding the recommended
width of a pencil or a quarter of an inch between the sensors for best
When you open and close the doors and windows, the two parts should separate when
unit
of the
n the frame to
placement, although it
Do not dispose of electrical appliances as unsorted municipal waste. Use separate collection
Contact your local government for information regarding the collection systems