Operation Manual

V 2.17t1
Oplink Communications, Inc.
Set up and wall-
mount the motion sensor
Step 1: Insert Battery
a. Lift top tab on cover to r
elease
b.
Insert the battery noting the polarity (CR123A), and
Step 2: Install Motion Sensor
a.
Place the motion sensor
area. The motion sensor monitors any movement up to 35 feet and should not be
placed higher than 7 feet
b. Use double-sided
tape to mount
c.
Make sure the motion sensor is
obstruction for best coverage.

Do not aim the detector at a staircase which a pet has access to.

Do not mount the detector near furniture or objects
onto (such as a couch within 6 feet of the detector)
Oplink Communications, Inc.
mount the motion sensor
elease
and remove cover.
Insert the battery noting the polarity (CR123A), and
replace the cover
onto the
Place the motion sensor
appropriately to ensure maximum
coverage of a monitored
area. The motion sensor monitors any movement up to 35 feet and should not be
placed higher than 7 feet
from the floor.
tape to mount
on the wall at the desired location.
Make sure the motion sensor is
p
laced at an angle with the least amount of
obstruction for best coverage.
Do not aim the detector at a staircase which a pet has access to.
Do not mount the detector near furniture or objects
higher than 4 feet tall which
a pet may climb
onto (such as a couch within 6 feet of the detector)
.
16
onto the
sensor.
coverage of a monitored
area. The motion sensor monitors any movement up to 35 feet and should not be
laced at an angle with the least amount of
a pet may climb