User's Manual

3
EU Declaration of Conformity (DoC)
Hereby, Guangdong OPPO Mobile Telecommunications Corp., Ltd. declares that this
wireless device is in compliance with the essential requirements and other relevant
provisions of Directive 2014/53/EU and 2011/65/EU.
The full text of the EU declaration of conformity is available at the following internet
Notice:
Observe national and local regulations where the device is used. This device may be
restricted for use, depending on the local network.
The operation frequency in 5150-5350MHz of Wi-Fi 5G are restricted to indoor
usage only.
Please check Radio Waves Specications in the Quick Guide to see whether this
product supports Wi-Fi 5G or not.
address: www.oppo.com/en/certication.
This device was tested for typical body-worn operations with the back of the handset
kept 0.5cm away. To maintain compliance with RF exposure requirements, use
accessories that maintain a 0.5cm separation distance between the user’s body and
the back of the handset. The use of belt clips, holsters and similar accessories should
not contain metallic components in its assembly. The use of accessories that do not
satisfy these requirements may not comply with RF exposure requirements, and
should be avoided.
If you are using pacemaker, hearing aid, cochlear implant or other device, please use
the phone according to the doctor’s advice.
Restrictions in the 5 GHz band
FCC Regulatory Conformance
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference; and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful to part interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution：
Any changes or modications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.