User's Manual

ADVANCED OPERATIONS

Output Resolution

RESOLUTION

The BDP-105 supports multiple output resolutions. For a detailed

discussion on how to choose the best output resolution, please

refer to the Select the Best Output Resolution section on page

25 of this manual.

If you would like to change the output resolution, you may do so by

pressing the RESOLUTION button on the remote.

1. Make sure the HDMI cable is properly connected.

2. Turn on the TV and adjust the TV to use its HDMI input port.

3. Make sure that the player is turned on. Although the output resolution can be changed while a disc is

playing, it

is recommended that you stop playback and take out the disc before changing the output

resolution. Press the RESOLUTION button. The Resolution Menu appears on the TV screen. If the

TV does not support the current resolution and you cannot see the Resolution Menu, the current

resolution is also displayed on the player’s front panel.

4. Use the UP/DOWN ARROW buttons to select the new output resolution. You may also press the

RESOLUTION button multiple times to cycle through the available output resolutions.

5. Press the ENTE

R button to apply the selected output resolution. If you do not want to change the

output resolution, press the RETURN button to exit and return.

The following output resolutions are available:

NTSC output:

4Kx2K

Auto 1080p(60Hz/24Hz) 1080i 60Hz 720p 60Hz 480p 480i Source Direct

PAL output:

4Kx2K

Auto 1080p(50Hz/24Hz) 1080i 50Hz 720p 50Hz 576p 576i Source Direct

NOTE

x Some TV sets may not support one or more output resolutions. If an incompatible output

resolution is selected, you will get a blank screen or an error message. If this occurs, please

select an output resolution that is supported by the TV.

x If you cannot get a picture using HDMI, please remove the HDMI cable and connect the

player’s DIAG (diagnostic) output to the TV using a regular composite video cable, and then

use the Setup Menu to adjust the player settings.

x Due to the “Analog Sunset” provision, as of January 1, 2011 all Blu-ray Disc players made

and sold going forward will not be able to pass high definition video (720p, 1080i, or 1080p)

via Component Video outputs. Because of this, we have removed the Component and