Datasheet

Slotted Optical Switch
OPB804
© TT electronics plc
Issue B 11/2016 Page 2
TT Electronics | Optek Technology, Inc.
1645 Wallace Drive, Ste. 130, Carrollton, TX USA 75006 |Ph: [phone]
www.electronics.com | sensors@electronics.com
General Note
TT Electronics reserves the right to make changes in product specicaon without
noce or liability. All informaon is subject to TT Electronics’ own data and is
considered accurate at me of going to print.
Absolute Maximum Rangs (T
A
= 25° C unless otherwise noted)
Storage Temperature Range -40°C to +100° C
Operang Temperature Range -40°C to +85° C
Lead Soldering Temperature 260° C
( 5)
Input Diode
Input Diode Power Dissipaon 75 mW
( 7)
Input Diode Forward D.C. Current, T
A
= 25°C 50 mA
( 7)
Input Diode Peak Forward Pulse Current, T
A
= 25°C (1µs pulse width, 300pps) 1 A
Phototransistor
Power Dissipaon 100 mW
( 7)
Collector - Emier Voltage 30V
Emier - Collector Voltage 5.0V
Electrical Specicaons
Electrical Characteriscs ( T
A
= 25°C )
SYMBOL PARAMETER MIN TYP MAX UNITS TEST CONDITIONS
Input Diode (see OP140 or OP240 for addional informaon)
V
F
Forward Voltage - 1.25 1.70 V I
F
= 20 mA
I
R
Reverse Current - - - - Not designed for reverse operaon
Output Phototransistor (see OP550 for addional informaon)
V
(BR)CEO
Collector-Emier Breakdown Voltage 30 - - V I
C
= 1 mA, E
E
= 0 mw/cm
2
V
(BR)ECO
Emier-Collector Breakdown Voltage 5.0 - - V I
E
= 100 µA, E
E
= 0 mw/cm
2
I
CEO
Collector Dark Current - - 100 nA V
CE
= 10 V, I
F
= 0, E
E
= 0 mw/cm
2
Coupled
V
CE(SAT)
Collector-Emier Saturaon Voltage - - 0.40 V I
C
= 250 µA, I
F
= 20 mA
I
C(ON)
On-State Collector Current 0.5 5 - mA V
CE
= 10 V, I
F
= 20 mA
Notes:
(1) Dot indicates # 3 collector lead side.
(2) Feature controlled at body.
(3) Cathode lead may be shorter.
(4) RMA ux recommended. Highly acvated water soluble uxes may aack plasc. Recommend trial to verify applicaon.
(5) Maximum lead soldering temperature .060” [1.6mm] from case for 5 seconds with soldering iron.
(6) Plasc is soluble in chlorinated hydrocarbons and ketones. Methanol or isopropanol are recommended as cleaning agents.
(7) Derate linearly 1.67 mW/°C above 25° C.
(8) All parameters tested using pulse techniques.
(9) Do not connect input diode directly to a voltage source without an external current liming resistor.
(10) Do not apply reverse voltage to LED. LED will be a 0V in reverse voltage and draw current as if a short.