User Manual

ManualsBrandsOptex ManualsElectronicsISeries IP Receiver for Milestone XProtect VMS and BTX Software Bundle

Table Of Contents

Notice
Document Part Number
Trademarks
Technical Services Contact Information
Document Conventions
EN6080 Area Control Gateway Overview
1.1 Introduction
1.2 Recommended System Requirements
1.3 EN6080 Area Control Gateway Initial Setup and Connection
1.3.1 Configure Network Settings (for Windows 7)
1.3.2 Disable Delayed ACK Mode on the Windows® 7 Operating System
1.3.3 Browse to the EN6080 Area Control Gateway Web Server Screens
1.3.4 License Key Setup
Home
2.1 Home
2.1.1 System Connection Summary
2.1.2 Device Information
2.2 Site Information
2.2.1 ACG Information
2.2.2 Contact Information
ACG Setup
3.1 User Administration
3.1.1 Update User or Admin Password
3.2 IP Administration
3.2.1 Configure a Static IP Address
3.2.2 Configure a DHCP IP Address
3.3 Date and Time Setup
3.3.1 Poll NTP Servers for Time and Date
3.3.2 Synchronize Time and Date with your PC
Partitions
4.1 Partitions
4.2 Define a New Partition
4.3 Assign Devices to a Partition
4.4 Remove Devices from a Partition
4.5 Update a Partition
4.6 Delete a Partition
Wireless Setup
5.1 Wireless Setup
5.1.1 Update the NID
Device Setup
6.1 Manual Administration
6.1.1 Manually Register a Device
6.1.2 Unregister a Registered Device
6.2 Automatic Administration
6.2.1 Start Discovery
6.2.2 Edit and Register the Devices
6.2.3 Unregister a Registered Device
6.3 Upload Administration
6.3.1 Upload a Spreadsheet of Devices to Register
Logs
7.1 Logs
7.2 Alarm Logs
7.2.1 Retrieve and Save Logs
7.3 System Logs
7.3.1 Retrieve and Save System Logs
7.4 Trouble Logs
7.4.1 Retrieve and Save Trouble Logs
File Management
8.1 System and Configuration Files
8.1.1 Back Up Configuration Files
8.1.2 Restore Configuration Files
8.2 Firmware Update
8.2.1 Update Firmware

Device Setup

Figure 6-4 Upload administration screen

6.3.1 Upload a Spreadsheet of Devices to Register

1. Click “Browse.”

2. Navigate to the .csv file of devices you wish to register.

3. Click “Open.”

4. Click the “Load” button.

5. All devices that parse properly and are unregistered will be selected by

default. Deselect any devices that you do not want to register.

6. Click “Register”.

Note: You can also unregister devices by highlighting the devices you want to unregister

and clicking “Unregister.”