User Manual
Table Of Contents
- Notice
- Document Part Number
- Trademarks
- Technical Services Contact Information
- Document Conventions
- EN6080 Area Control Gateway Overview
- 1.1 Introduction
- 1.2 Recommended System Requirements
- 1.3 EN6080 Area Control Gateway Initial Setup and Connection
- 1.3.1 Configure Network Settings (for Windows 7)
- 1.3.2 Disable Delayed ACK Mode on the Windows® 7 Operating System
- 1.3.3 Browse to the EN6080 Area Control Gateway Web Server Screens
- 1.3.4 License Key Setup
- Home
- 2.1 Home
- 2.1.1 System Connection Summary
- 2.1.2 Device Information
- 2.2 Site Information
- 2.2.1 ACG Information
- 2.2.2 Contact Information
- ACG Setup
- 3.1 User Administration
- 3.1.1 Update User or Admin Password
- 3.2 IP Administration
- 3.2.1 Configure a Static IP Address
- 3.2.2 Configure a DHCP IP Address
- 3.3 Date and Time Setup
- 3.3.1 Poll NTP Servers for Time and Date
- 3.3.2 Synchronize Time and Date with your PC
- Partitions
- 4.1 Partitions
- 4.2 Define a New Partition
- 4.3 Assign Devices to a Partition
- 4.4 Remove Devices from a Partition
- 4.5 Update a Partition
- 4.6 Delete a Partition
- Wireless Setup
- 5.1 Wireless Setup
- 5.1.1 Update the NID
- Device Setup
- 6.1 Manual Administration
- 6.1.1 Manually Register a Device
- 6.1.2 Unregister a Registered Device
- 6.2 Automatic Administration
- 6.2.1 Start Discovery
- 6.2.2 Edit and Register the Devices
- 6.2.3 Unregister a Registered Device
- 6.3 Upload Administration
- 6.3.1 Upload a Spreadsheet of Devices to Register
- Logs
- 7.1 Logs
- 7.2 Alarm Logs
- 7.2.1 Retrieve and Save Logs
- 7.3 System Logs
- 7.3.1 Retrieve and Save System Logs
- 7.4 Trouble Logs
- 7.4.1 Retrieve and Save Trouble Logs
- File Management
- 8.1 System and Configuration Files
- 8.1.1 Back Up Configuration Files
- 8.1.2 Restore Configuration Files
- 8.2 Firmware Update
- 8.2.1 Update Firmware
EN6080 Area Control Gateway Overview
7.28.17 06443H © 2017, Inovonics - www.inovonics.com 8
1. From the control panel, click “Network and Internet.”
2. Click “Network and Sharing Center.”
3. Click “Change adapter settings.”
4. Right click on the local area connection used to connect to the network,
and select “Properties.”
5. Double click “Internet Protocol Version 4 (TCP/IPv4).”
6. Select the “Use the following IP address” radio button.
7. Set the IP address to 192.168.60.1.
8. Set the subnet mask to 255.255.255.0.
9. Click “OK.”
1.3.2 Disable Delayed ACK Mode on the Windows® 7 Operating
System
The EN6080 area control gateway currently does not respond to the delayed
ACK mode of operation that some Windows 7 machines use. Microsoft has
provided a fix for this as outlined below.
To disable delayed ACK mode in Windows 7 Service Pack 1 or above: