Manual

-6-
5
Transmitter
6
Place the battery lead (included in the
set) and a dummy battery in the battery
case of transmitter.
Connect the alarm cable to the
transmitter and close the cover.
Dummy battery
* Twist and cut off the portion that fits the applicable
battery type.
CR123A
CR2
1/2AA
1/2AA
Alarm cable
Put the alarm wire outside
through the wiring hole
BATTERY LEAD(red)
BATTERY LEAD(black)
Dummy battery
Open the claws (at 2 places).
Open the claws (at 2 places) slightly.
Disengage the bosses
(at 2 places).
Pull
Lift and remove
Remove the battery box from the main
unit.
Remove the battery box cover.
Do not use batteries of different capacities (i.e.: mixing new and used batteries) or of
different manufacturers and/or types together. Not observing the above may result in
an explosion, leakage of electrolyte, emission of toxic gases or other outcomes that
may be harmful to people and property.
Warning
1
2
-Battery Sharing Impossible Case
Arrange 3 cells each of CR-123A (recommended) or CR2.
CR123A CR2
After installing the batteries, check the
guide on the side and install the cover.
Hook the cover firmly by the claws on the
right and left sides.
Do not contact the ends of the red
and black wires to avoid short-
circuit.
Caution>>
3
Transmitter
Alarm cable
Put the alarm wire outside
through the wiring hole
Connect the alarm cable to the
transmitter and close the cover.
4