Manual

- 2 -
- 3 -
ENGLISH FRANÇAIS DEUTSCH ITALIANO ESPAÑOL
DETECTION AREA SETTING
You can adjust the detection area by 90 degrees in a horizontal
direction and by 10 degrees in a vertical direction.
Correct the vertical detection angle according to the mounting
height of the sensor unit.
Applicable models
SIP-3020WF SIP-4010WF SIP-404WF
10°
10°
90°
90°
SIP-3020CAM DN
Cautions>>
To rotate the main unit counterclockwise, loosen the
RHside adjustment screw. To rotate the main unit
clockwise, loosen the LH-side adjustment screw.
Otherwise, you may find it difficult to tighten or you may
find that you cannot tighten the adjustment screw when
you are securing the main unit.
To rotate the unit counterclockwise To rotate the unit clockwise
4
Adjust the angle of the main unit in a horizontal direction so
that you can cover the desired detection area.
Adjust the angle of the main unit in a vertical direction so
that you can cover the desired detection area.
Cautions>>
If the mounting wall is at an angle, the arrow of the
mainunitmayexceedthetoporbottomlimitof“Angle
adjustment guide”. Always check this using the area
viewfinder or the walk tester. If the detection area is
too high or too low, an object outside the detection
area may be detected or incorrect object detection may
occur.
Remove the cover.
Cautions>>
The cover is linked to the main unit by nylon wire loop so
that the cover does not fall. Do not pull the cover using
excessiveforce.
(1)
(2)
(3)
When mounted at a
height of 4.0 meters (13ft.)
3 Rotate the main unit.
2 Loosen the adjustment screw.
4 Tighten the adjustment screw slightly.
Hooks
3 Slide the cover downward
and release the hooks.
1Loosentwoxingscrewsfor
the cover and pull out the
cover until it stops.
Cover
2Holdtheheadsofbothcoverxingscrewswithyour
hands, and pull down and remove the bottom section
of the cover from the main unit.
Adjustment
screw
1Loosenthexingscrewfor
the base.
When mounted
at a height of
2.3 meters
(7.6ft.)
Align the arrow of the main
unitwiththe“Angleadjustment
guide” of the adjustment
screw. The main unit is usually
adjusted within the width of this
guide.
REDWALL-V_SP-WF_EN.indd 3 2009/05/19 15:46:25