User's Instructions

Assembly & User Instructions - Please keep for future reference

750/8536

OPTI 7FT X 5FT Metal Football Goal

Important – Please read these instructions fully before assembly or using

These instructions contain important information which will help you get the best from your

equipment and ensure safe and correct assembly, use and maintenance.

If you need help or have damaged or missing parts, call the Customer Helpline:0345 6402020

1 Top. & Bottom curve x 4

2. Middle Straight x 2

3. Top Post Upright x 2

4. Bottom Post Upright x 2

5. Bottom End L/H x 1

6 Bottom End R/H x 1.

7 Top Back Curve x 2.

8 Rear Connector x 2.

9 Bottom Back Curve x 2.

Components - Parts

Open all packaging and organise all straight and curved poles into numbered groups.

Each pole will have a number on it (1-9) matching the parts list above.

To connect the poles together, slide the

smaller connecting end inside the

corresponding pole end. Some poles will have

a connecting button to lock poles together.

Simply press this button down, while sliding it

inside a connecting pole, as shown.

Note: If this joint feels tight to assemble a little

washing up liquid on the small connecting end

will help slide together.

Follow the numbered diagram below and

assemble top curve (1) to middle straight (2)

to complete to top frame.

IMPORTANT: Attach the net at this

point. As you build each part of the

frame, you will need to thread the

loops at the edge of the net over

each part of the frame poles. The

end result should be the net (B)

hangs from the top bar and down to

the back oor frame.ﬂ

Assemble Instructions

Issue 1 9/26/16

PAGE 1
OPTI 7FT X 5FT Metal Football Goal Assembly & User Instructions - Please keep for future reference 750/8536 Components - Parts 1.Top & Bottom curve x 4 6.Bottom End R/H x 1 2. Middle Straight x 2 3. Top Post Upright x 2 4. Bottom Post Upright x 2 5. Bottom End L/H x 1 7. Top Back Curve x 2 8. Rear Connector x 2 9. Bottom Back Curve x 2 Assemble Instructions Open all packaging and organise all straight and curved poles into numbered groups.
PAGE 2
Assemble Instructions Continue to build the frame using tubes 3 to 6 again remember to thread the net throught the top and bottom post uprights (3 & 4) also the bottom curve and middle straight (1 & 2) at the rear on the ﬂoor. Ensure all button clips are seated and secure. Pre-assemble the top and bottom back curves to the rear connecting tubes(7 & 8). Then insert this assembly from the front of the goal, which will push out the net to form the goal shape.