User's Instructions

Assembly Instructions
13
Step 6
The Handlebar Spacer (40) is
pre-fitted onto each side of the
Handlebar Upright Pivot Bar
as shown. Slide 1 x M19 Wave
Washer (47) onto each side of
the Handlebar Upright Pivot Bar.
Slide the assembly onto the Pivot
Bar and secure in place
with 1 x M8 x 20mm Allen Bolt
(88), 1 x ø8.5x13 Spring Washer
(70), 1 x ø8.5 x 25 Flat Washer
(66) and 1 x ø19.5 x 28 D Washer
(65) for each side. Fit the correctly
labeled (L or R) Dual Action
Handlebar – Upper (22 / 23) into
the appropriate Dual Action
Handlebar – Lower (26L / 26R) and
secure in place using 4 x M8 x
40mm Hex Bolts (52), 4 xø8.5 x 16
Curved Washers (69)
4 xø8.5 x 13 Spring
Washers (70) and 4 x M8
Dome Nuts (74). Fit Round
Caps (51) to the Dual Action
Handlebar-Upper (22 / 23).