User guide

USER’S MANUAL PHL2700 TERMINAL / IRU2700 CRADLE
12
2.5.5 How to (re)place the main battery
in the terminal?
Only use batteries as specified in
paragraph 2.5.1.
If you have data stored, make sure the
backup battery is placed and full
enough, to avoid data loss.
Before installing a battery
case with penlite batteries:
Make sure you use
the right battery size.
Place 2 batteries in the
battery holder aligning
plus (+) and minus (-)
ends as shown on the
battery holder.
The instructions for installing the rechargeable
battery pack are also applicable for the battery
case with penlite batteries.
Unlock cover: Open the switch (shift to
the right) and remove the battery case
cover (ref. 1)
Remove main battery pack:
Hold your tumb over the right wing of the
battery case. (ref. 2a).
Press the wing and lift the battery on the
right side. (ref. 2b).
The battery can now be taken out.
Position main battery:
Take the battery case.
Check if the charging contacts of the case
align with the contacts inside the battery
compartment (ref. 3)
Fit main battery pack:
First place the left side of the battery case
into position (ref. 4a).
Click the left wing untill it fits followed by
clicking the right wing. (ref. 4b)
Fit cover: Place the battery case cover
and lock the switch (shift to the left)
(ref. 1)
!
!
2b
3
1
3
----> open
close <----
2a
4b4a