Assembly Instructions

floor Scale Assembly Guide
1. Carefully open box and remove scale
2. Locate compartment (found on side of scale) and remove the screws
3. Remove all contents - indicator cable, power cable, manual and indicator bracket
NOTE: Indicator will be shipped separately
4. Feet will be in a bag on the underside of the scale (between frames)
5. Screw feet into the load cells until scale is leveled
NOTE: Do not screw in too deep that it will touch the platform
6. Place scale on at surface and make sure scale is stable
7. Route the indicator cable inside the compartment through an available opening
(inside compartment) and connect to the indicator
8. Close compartment latch with screws
9. Connect the indicator and power on
10. Once indicator is powered on, display will count down and be zeroed out
(no calibration needed). Scale is ready for use
11. If indicator does not count down and zero out, calibration will be needed
(please refer to manual for proper calibration steps)
Please call 1(800) 360-9619 ext. 2 for support questions
For updated indicator manual, please refer to www.OptimaScale.com “Downloads”
Feet found under scale.
INDICATOR SHIPPED SEPARATELY
ALL ACCESSORIES
INSIDE COMPARTMENT