Home Theater System User Manual

ManualsBrandsOptimus ManualsHome Theater System120-1725

Three-Way Bass Reflex Car Speaker System

(120-1725) Features Faxback Doc. # 38063

Your Optimus Three-Way Bass Reflex Car Speaker System is designed to give

you clean sound with powerful bass. The system is ideal for rear-deck

mounting.

To get the best sound from your speakers, please read all of these

instructions carefully for the proper wiring and mounting procedures.

BEFORE YOU BEGIN

We recommend that you connect your autosound system to the speakers before

you mount them so you can test the speakers and the wire connections. When

you verify that everything works properly, turn off your autosound system

and mount the speakers.

NOTE: If you are unsure about the following installation process, we

recommend that you have a professional install the speakers.

Summary of content (8 pages)

PAGE 1
Three-Way Bass Reflex Car Speaker System (120-1725) Features Faxback Doc. # 38063 Your Optimus Three-Way Bass Reflex Car Speaker System is designed to give you clean sound with powerful bass. The system is ideal for rear-deck mounting. To get the best sound from your speakers, please read all of these instructions carefully for the proper wiring and mounting procedures.
PAGE 2
Three-Way Bass Reflex Car Speaker System (120-1725) Wiring the Speakers Faxback Doc. # 38064 Connect two speakers to your auto sound system as shown. NOTES: If your autosound system has a front-to-rear fader, follow the instructions in the audio component's manual for the correct speaker connections. To ensure proper phasing, match the speaker wires to the corresponding red (+) or black (-) speaker terminals. Improper phasing can cause poor bass response.
PAGE 3
mounting position. Then determine the center of the mounting position. 3. Drill a hole 1/4-inch wide in the center of the mounting position. 4. Attach the bolt to the bottom of the speaker cabinet and secure the bolt using a Phillips screwdriver. 5. Position the speaker cabinet on the mounting surface by inserting the bolt through the drilled hole. 6. Underneath the mounting surface, place the washer over the bolt. Then thread and tighten the wing nut until the speaker cabinet is secure.
PAGE 4
Three-Way Bass Reflex Car Speaker System (120-1725) Specifications Faxback Doc. # 15674 Crossover Capacitor Size................................................................5x11 mm Capacitance.....................................2.2 micro Farad, 50 V (B/P) Speaker Size: ........................................... 3 1/2-inch woofer 2-inch midrange 1 1/2-inch tweeter Barium Magnet Weight: ............................................. 5.36 oz Power Handling Capacity: ....................................
PAGE 5
Audio Connection Information (120-Series) Plug/Male 2 Ch. System Faxback Doc.# 19994 +----+--------------+---------------+------------+------------------------+ |Pin | | | | | |No. | WIRE COLOR | WIRE SPECS.
PAGE 6
(2CH/4CH SWITCHABLE UNIT) +----+--------------+---------------+------------+------------------------+ |Pin | | | | | |No. | WIRE COLOR | WIRE SPECS.
PAGE 7
|Pin | | | | | |No. | WIRE COLOR | WIRE SPECS.
PAGE 8
+---------+--------------+ | White | Right (-) | +---------+--------------+ | Brown | Left (+) | +---------+--------------+ | Gray | Left (-) | +---------+--------------+ | Red | +12 V Power | +---------+--------------+ REAR +---------+--------------+ | GRN/BLK | Right (+) | +---------+--------------+ | WH/BLK | Right (-) | +---------+--------------+ | BR/BLK | Left (+) | +---------+--------------+ |GRAY/BLK | Left (-) | +---------+--------------+ +---------+--------------+ | Orange | S.P.L.