User manual

2
2
Using the Remote Control
The remote control works up to a distance of about 23 feet, and within a 30-
degree angle on either side of the receiver. Point the control at the receiver’s
front panel and press the desired button(s).
Many buttons on the remote control work the same as buttons on the receiver’s
front panel. Use these buttons exactly as you would use the corresponding but-
tons on the receiver.
AUDIO
/
VCR Switch
The remote control can also control other compatible audio/video components
when you connect them to the receiver’s
CONTROL OUT
jack. Set the switch to
AUDIO
to control audio components such as CD players or cassette decks. Set
the switch to
VCR
to control video components such as a VCR.
When you set the switch to
VCR
, dual-function buttons control the function
marked in gold next to the button. For example, the button marked
CENTER
MODE
and
TEST TONE
operates as the center mode adjust when you set the
switch to
AUDIO
and as the delay time function when you set the switch to
VCR
.
Receiver/Amplifier Section
FUNCTION
Selects a pro
g
ram source (VCR/Tape 1, LD, CD, tuner, or
phono). Repeatedly press
FUNCTION
until the display shows
your desired pro
g
ram source. See Pa
g
e 14.
– MASTER VOLUME +
Adjusts the system’s volume. See Pa
g
e 14.
CENTER MODE
Selects amon
g
the three center mode settin
g
s with
AUDIO
/
VCR
set to
AUDIO
. See Pa
g
e 21.
– CENTER +
Controls the relative volume of the center speaker with
AUDIO
/
VCR
set to
AUDIO
. See Pa
g
e 21.
– REAR +
Controls the relative volume of the rear speakers with
AUDIO
/
VCR
set to
VCR
. See Pa
g
e 21.
TEST TONE
Sounds test tones from each speaker with
AUDIO
/
VCR
set to
VCR
. See Pa
g
e 21.
DELAY TIME
Sets the rear-channel delay for Dolby Pro-Lo
g
ic Surround
and Simulated Surround pro
g
rams with
AUDIO
/
VCR
set to
VCR
. See Pa
g
e 21.
SURR MODE
Selects between Dolby Pro-Lo
g
ic Surround or Simulated Sur-
round sound. See Pa
g
e 20.
SLEEP
Sets the receiver to turn off after 90, 60, or 30 minutes with
AUDIO
/
VCR
set to
AUDIO
. To start the timer, repeatedly
press
SLEEP
until the desired turn-off time (
90
,
60
, or
30
)
appears. To cancel the timer, repeatedly press
SLEEP
until
the sleep time disappears from the display. See Pa
g
e 17.
RECEIVER POWER
Turns the receiver on and off. See Pa
g
e 14.
RETURN
Returns the receiver to its default settin
g
s. See Pa
g
e 27.
3CH LOGIC
Selects Dolby 3CH Lo
g
ic. See Pa
g
e 20.
TAPE 2 MONITOR
Switches the receiver to monitor the source connected to the
TAPE 2 MONITOR
jacks. See Pa
g
e 18.