User's Manual

iCON
®
452 User Guide
Version: v007ext Page: 26 of 28
2. Certification requirements
2.1 Federal communications commission notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
we cannot guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio or television technician for help.
2.2 Modifications
The FCC requires the user to be notified that any changes or modifications made to this device that are not
expressly approved by Option
®
, could void the user's authority to operate the equipment.
T
his device complies with Part 15 of the FCC rules.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesirable
operation.
2.3 Exposure Information to Radio Frequency Energy
This USB 2.0 device has been tested in a notebook for compliance with the SAR requirements as stated by the
FCC.
Users concerned with the risk of Radio Frequency exposure may wish to limit the duration of their calls and to
position the antenna as far away from the body as is practical.
The USB Stick has been tested with specific integral antenna for SAR compliance with one notebook having
vertical and horizontal USB slots with a separation distance of 5mm between the panthom and the device. The
device can be used in notebook computers with substantially similar physical dimensions, construction, and
electrical and RF characteristics.
2.4 Manufacturer's disclaimer statement
The information in this document is subject to change without notice and does not represent a commitment on the
part of the vendor. No warranty or representation, either expressed or implied, is made with respect to the quality,
accuracy or fitness for any particular purpose of this document. The manufacturer reserves the right to make
changes to the content of this document and/or the products associated with it at any time without obligation to
notify any person or organization of such changes. In no event will the manufacturer be liable for direct, indirect,
special, incidental or consequential damages arising out of the use or inability to use this product or
documentation, even if advised of the possibility of such damages.
For questions regarding your product or declaration, contact:
Option | Gaston Geenslaan 14 | 3001 Leuven | Belgium | www.option.com
2.5 System requirements
• USB 2.0 slot.
• Must be supplied by a SELV (Safety Extra Low Voltage) circuit with limited power.
For questions regarding your product or FCC declaration, contact:
Option | Gaston Geenslaan 14 | 3001 Leuven | Belgium | www.option.com
To identify this product we refer to the Part, Series or Model number found on the product.