User's Manual

(7) Connect the external antenna (or SMA connector cable for test equipment) to the
RF connector on the module.
Figure 7: RF connector on the module
(8) Connect the headset into the audio jack. Next, (9) connect the power supply plug (the
adapter should already be connected to the mains) to the evaluation platform. And when you
are ready you can (10) connect the USB cable from the GTM cradle to your PC. At this point your
module should be detected by the host PC. Proceed with the next Chapter.
Figure 8: Top to bottom: USB cable, power plug and audio jack
NOTES:
In case a hard reset of the unit is necessary, unplug the power supply and wait until the power led
(led closest to the fan) is fully extinguished before reconnecting the power supply (A large buffer
capacitor on the cradle board needs about 10 seconds to discharge).
10
7
9
8
G L O B E T R O T T E R Q U I C K S TA R T G U I D E
PAGE: 8 of 30
AUTHOR: G. Van Overbeke | CREATION DATE: Aug 8, 2006 | VERSION: v01-f3
[ OPTION CONFIDENTIAL ]