AutoSense™ II Inbound Standalone Installation Manual Cargo Monitoring Solutions
Table of Contents Page 3 Page 3 Page 4 Page 4 Page 5 Page 6 2
Equipment Inventory List: (Equipment may vary) • AutoSense Standalone • 6ft. Low Voltage Extension Cord • Rubber Reader Antenna • 2 Cellular Paddle Antennas • 100-240VAC Power Supply Installation Hardware: • Cable Ties • Cable Tie Mounts Kit Equipment • Mounting Screws • Cable Clamps • Test Logger AutoSense Standalone Installation 1. Attach the 2 cellular paddle antennas and the single rubber reader antenna. 2. Mount on wall at least 6 ft. up and in front of dock doors using one of these methods: a.
Cellular Connectivity 1. Angle antennas away from the wall 2. After power is applied, verify the LEDs to right of the ethernet port are lit correctly a. Left LED is a solid GREEN indicating system is operational b. Middle LED is solid GREEN indicating connection to cellular carrier c. Right LED is GREEN or AMBER indicating cellular strength Green Light System Verification Stand at the farthest receiving area/dock door from the AutoSense Standalone.
Regulatory Approvals PakSense, Inc. Model: PSASII-03; FCC ID WPEPSASII-03; IC: 8031A-PSASII03 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Technical Support Technical Support is available 24 hours a day, 7 days a week. We’re with you every step of the way. Toll Free: +1-877-998-7299 Emerson.com/Cargo CargoSupport@Emerson.com ASIS.UM.Rev1.0220 Emerson is a trademark of Emerson Electric Co. or one of its affiliated companies. ©2020 Emerson Electric Co. All rights reserved.
