Owner's manual

DVR Server Manual ver.5.05/rel.092507
3
1. Full screen
Single-Right- Click image area, it will popup a menu, then select ―full screen‖ to change the
display mode to full screen (or press F12 on the keyboard). When you want to resume normal mode,
you should Single-Right- Click image area and select ―Restore display‖.
2. Instant playback
3. Alarm popup
Single-Right-Click desired camera window and select
―Instant playback‖. However, IP Camera‘s instant playback can
only be done doing a right click on a currently unused video
display window.
A submenu will be shown for you to choose a preset length
of time of instant playback .
The window that is playing back video data will indicate a
yellow border to be different from the live windows.
In the course of the instant playback, you can press Space
key to switch the play/pause status or direction key → and ←
to play next and previous frame.
If you want to stop the instant playback, you can
Single-Right-Click the play backing window, and select ―End
playback‖.
First, enable ―Alarm camera pop-up interval‖ in System Setup‖
menu by selecting the time interval in seconds. Single-Right-Click
video image area at the main interface and select ―Start alarm
popup‖. After setting up all these configurations, when there is a
motion detection alarm (set in PTZ & Linkage setup and Motion
detection setup) or an alarm triggered by sensor (set in Sensor
setup), system will display alarm cameras in sequence. When you
want to end this function, you can Single-Right-Click video image
area and select ―Pause alarm popup‖. (This functionality does not
apply IP camera through the IP Video Server, even IP camera have
alarms, their images will not pop up).