User's Manual

CRD-3301 SS08xxx
7
7. DIPSW configurations
Following functions can be set by DIPSW as shown.
DIPSW No. Function
DIPSW1 Make sure the it is always OFF when using the cradle.
This will be used for feature expansion.
DIPSW2 Enables inquiry scan withiout security
Connection can be made witout authentication.
DIPSW3 Disables protocol while in connection.
The menu allows the cradle to connect to bluetooth devices
including OPR-3301.
DIPSW4 Disable DTR signakl detection for the host.
DIPSW5 Sets the cradle to the default.
(Sets the contents of FLAH ROM to the initial setting.)
DIPSW6 It is normally OFF.
When it is ON, *“software update mode” operates
* With in this mode, software is rewitten via RS232C interface.
Note: 1. All DIPSWs are available when power ON.
2. In the default setting, SW6 is ON, rest of them are OFF.
How to set DIPSW
DIPSW
Setting
SW1 SW2 SW3 SW4 SW5 SW6
N/A X X X X OFF OFF
NO SECURITY X ON X X OFF OFF
NO PROTOCOL X X ON X OFF OFF
IGNORE DTR X X X ON OFF OFF
INITIAL SETUP X X X X ON OFF
DOWNLOAD MODE X X X X X ON
X : Don’t Care
Figure3: Location of DIPSW
1 2 3 4 5 6
ON