User Manual

7．Wireless Connection

7.1 Wireless Specifications

OPI-4002 and OPA-1001 employs the Wireless communication standard IEEE802.15.4 as a wireless interface.

Connection:

Scanner 1 : Wireless USB Adaptor 1

Connection mode:

Address recognition (perform the communication by recognizing registered address.)

Encryption:

Support 128 bit-key Advanced Encryption Standard (AES).

Distance

Approx. 30 m (depends on use environment )

7.2 Settings via menu bar codes

The following wireless connection can be configured by reading the bar codes listen on page 19. 20 and 21.

・ Registration to wireless USB adaptor (decide the host computer of scanner)

・ Wireless channel settings (set communication channel of scanner and dongle)

・ Communication control settings

・ Data memorizing settings outside of communication area.

Data Memorizing Settings Outside of Communication Area

<Data Memorizing Disabled> (factory default setting)

Bar code data is not stored automatically, in case the connection is lost.

- Scanning operation is enabled outside of communication area of OPI-4002. Bar code data is stored

automatically.

- Maximum capacity of memory is approximately 100 K Bytes.

- Beeps go off when data volume exceeds the capacity of the memory during the scanning operation

carried out outside of the communication area. Scanning operation will be disabled at once. As soon

as OPI-4002 is connected again, the temporary stored data is transmitted to the computer and the

storage area is cleared.

- Automatic transmission of temporary stored data is done in a random cycle of 1.0 to 2.0 seconds.

- When data clear menu bar code 「+-MCLR-+」 or IEEE address label is scanned during the

re-transmission of bar code data outside of communication area (while orange LED is blinking),

re-transmission of bar code data will stop and bar code data stored in the memory will be deleted.

- When “Clear All Memorized Data” is selected during the scanning operation outside of communication area,

all memorizing data will be deleted and the memory will be cleared.

- These settings are not default settings.