User Manual

9.2 Default Settings 2: Read Options, Trigger, Buzzer, LED settings
Item Default settings
Setting the number of characters Fixed length OFF all codes
Read mode Multiple read
Inter-character gap check (NM-7) Character *1 > Inter-character gap
Multiple columns read (bar code only) Disabled
Trigger switch Enabled
Read time 2 seconds
Buzzer durations
200 msec
Buzzer tone
3kHz＋2.5kHz
Buzzer loudness Maximum
LED indicator duration 200 msec
9.3 Default Settings 3: Communication settings
Item Default settings
Disabled
IIEEE address
Wireless Channel CH15
Encryption Enabled
Memorizing Disabled
10．Menu Bar Code Labels
This section contains the menu bar code labels for OPI-4002 default settings.
Other menu labels are listed in the Universal Menu Book, such as Code options, String options, Read options, and Indicator
options. Please use it to set the required options for setting up the scanner to optimize its performance.
10.1 Setting Method
There are two ways to set the required options.
Setting 1. Scanning CODE39 bar codes:
To set the required options, proceed as follows: Scan the Set label, the required label, and the END label in sequence.
* If several labels in the same option are read, the last label read is enabled.
Setting 2. Scanning QR code:
This needs to scan directly without reading the “SET” and “END” labels.
36